Submission details

avatar

- Extreme League

6min 4sec 557ms with AMD Ryzen 9 3900X at 5752MHz

Ranking position

n/a

Global rank:

n/a

Ryzen 9 3900X rank:

Points earned for overclocker league

Points earned for team league

Media gallery

Screenshots
SuperPi - 32M screenshot
screenshot
screenshot
screenshot
ROG Crosshair VI Hero
ROG Crosshair VI Hero
Youtube

Hardware details

CPU details

Memory details

VGA details

  • Speed: MHz / MHz (Stock)

Mainboard details

Disk details

Power details

  • Series: MasterWatt Maker
  • Power: 1,200 Watt

Recent Comments

Australia KaRtA commented on his own score:

AMD 32m pi record back in my hands. Tough to manage, but really need 5.8G chip to crack the 6 minute mark, or maybe another board. Thanks to all my supporters, Cooler Master and ASUS Australia.

Australia robbo2 says:

Wow! nice one man

Bilko says:

Congrats mate, nicely done :)

FlanK3r says:

I like it and believe to find better chips. Can ask local Asus for C7H.

Australia cbjaust says:

C6H FTW!

Germany ground1556 says:

Isn't the C6H T-top? And since the IMC can't sensibly run more frequency (limited by fclk ratio) moving to 4 dimms or Dual Rank dimms could be a possibility for a little bit more performance maybe? 

Australia KaRtA says:

Thanks everyone.

It’s a really tricky one on this platform, as scaling just falls away very quickly. If it scaled correctly like my spreadsheets it should have been much faster, but after 5-5.2g it really takes a hit. This run was with 1.5s greater efficiency at 4ghz, but only 0.2s faster at full out.

 

I tried 4 dimms, but unfortunately The board either doesn’t like mixed PCB types, or I have a bad slot which is most likely the issue. I never had had much success with 4Dimms on this board, and the 1st and 3rd are difficult to get to boot even with 2 dimms. I don’t have any 16gb dimms so cannot test it. 

 

 

Australia zeropluszero says:

YTB

United States yosarianilives says:

On 8/25/2019 at 4:03 PM, KaRtA said:

I tried 4 dimms, but unfortunately The board either doesn’t like mixed PCB types, or I have a bad slot which is most likely the issue. I never had had much success with 4Dimms on this board, and the 1st and 3rd are difficult to get to boot even with 2 dimms. I don’t have any 16gb dimms so cannot test it. 

I hear ryzen has a much easier time with 4 sticks of micron rev e than 4 stick of bdie, so if you ran 4 sticks of bdie you may have a bad time.

Please log in or register to comment.